top of page

ClimateMaster CXM2 & DXM2.6 Fault Codes and Troubleshooting

aleena854
5 days ago
1 min read

Use these ClimateMaster troubleshooting tables to diagnose heat pump faults in the field. Each PDF organizes LED flash codes and operating symptoms by possible cause and recommended troubleshooting steps, with columns indicating whether each entry applies in heating or cooling.

Download the troubleshooting table for your control board


Confirm the control board model before using the table to interpret a flash code.



Diagnose by LED flash code or operating symptom


If a fault code is present, locate the flash code in the table and use the HT (heating) and CL (cooling) columns to narrow the possible causes for the operating mode. Both tables cover high- and low-pressure faults, water- and air-coil low-temperature limits, condensate faults, over- and undervoltage, and low water flow. The DXM2.6 table also includes a low ECM RPM fault.


If no fault code is present, start with the observed symptom. Both tables include diagnostic entries for short cycling, fan-only operation, compressor-only operation, and units that fail to operate in cooling.

Record the board model, flash code or symptom, operating mode, and relevant readings on the service ticket to document the conditions observed during diagnosis.

Comments

Rated 0 out of 5 stars.
No ratings yet

Add a rating

Address

2655 SE Enterprise Drive

Grimes, IA 50111

Phone

Email

Connect

  • Facebook
  • LinkedIn

© 2026 by VHF Sales, Inc. All Rights Reserved.

bottom of page